Differences

This shows you the differences between two versions of the page.

--- droidstar_mmdvm_based_m17_ht [2021/11/25 19:26]
nicolas
+++ droidstar_mmdvm_based_m17_ht [2021/11/25 23:13] (current)
nicolas
@@ Line 6: / Line 6: @@
 **This document is very much a work in progress, None of it is warranted as Correct, Accurate or Optimal.. Suggestions very welcome.**
-{{:wiki:m17droidtransceiver.jpg?350}}
+{{:wiki:m17droidtrx.jpg?350|}}
 ** Requirements **
@@ Line 92: / Line 92: @@
 ** USB to TTL adapter board **
-Using a Silabs CP2102 USB to TTL board (others could be used). This board has proved very reliable and provides a 3.3v output and 3.3 volt levels for the RX and TX. Beware some boards provide 5 volt RX and TX output, these risk damaging your Hotspot board.
+Using a Silabs CP2102 USB to TTL board (others could be used). This board has proved very reliable and provides a 3.3 Volt output and 3.3 Volt levels for the RX and TX. Beware some boards provide 5 Volt RX and TX output, these risk damaging your Hotspot board.
-** Cable to connect the USB TTL board to the Pi Hotspot Board. **
+{{:wiki:m17usbttlboard.jpg?400|}}
-Pi Header pin 6 for ground, pin 1 for 3.3V, and pin 8 for TX Data from the Pi, and pin 10 for RX Data into the Pi. [[https://www.theengineeringprojects.com/2021/03/what-is-raspberry-pi-zero-pinout-specs-projects-datasheet.html|Pi Header Spec]] Note that some USB TTL boards may have RX and TX "Swapped"
-{{:wiki:m17usbttlboard.jpg?400|}}
+** Cable to connect the USB TTL board to the Pi Hotspot Board. **
-USB TTL board with cable connecting it to..
+Pi Header pin 6 for ground, pin 1 for 3.3 Volt, and pin 8 for TX Data from the Pi, and pin 10 for RX Data into the Pi. [[https://www.theengineeringprojects.com/2021/03/what-is-raspberry-pi-zero-pinout-specs-projects-datasheet.html|Pi Header Spec]] Note that some USB TTL boards may have RX and TX "Swapped"
 {{:wiki:m17hotspotboard.jpg?400|}}
-The Hotspot board.
 ** USB OTG lead **
@@ Line 116: / Line 114: @@
 {{:wiki:m17serial_usb_terminal.png?350|}}
-==== Running DroidStar M17 Tranceiver ====
+==== Running DroidStar M17 Transceiver ====
 TBA
@@ Line 124: / Line 122: @@
 ==== Optional - Build the DroidStar Software For Linux and Android ====
-Building DroidStar requires the Qt toolset and development environment, to build DroidStar Android the Android toolset, frameworks and NDK etc are also required.
+Building DroidStar requires the Qt toolset and development environmen. To build DroidStar Android the Android toolset, frameworks and NDK etc are also required.
 ** Qt Prerequsites **

ZBM2

User Tools

Site Tools

Differences

Page Tools