Differences

This shows you the differences between two versions of the page.

--- 3d_printing [2025/07/28 12:15] – nicolas
+++ 3d_printing [2025/09/21 11:16] (current) – nicolas
@@ Line 1: / Line 1: @@
+===Elegoo===
+STL Repair
+https://formware.co/OnlineStlRepair
+Todo
+https://github.com/SoftFever/OrcaSlicer/wiki/Calibration
+Slicer VFA calibration print
+Measure filament
 .72 or 1.75 mm
@@ Line 55: / Line 66: @@
 https://github.com/eugr/Flashforge-for-Cura?tab=readme-ov-file
+Overhangs curling upwards
+If curling happens in places that have no bed contact: Too much cooling.
+Try reducing cooling to 50%
+Raise nozzle temp to 200C
+Lower board temp to 50C
+Last but not least: in Cura, there is a "Z Seam Alignment" option that I now use, and would suggest anyone to set on "random" (it isn't by default)
@@ Line 69: / Line 91: @@
 Bed 61, 60
 Max print speed 60
+===Elegoo===
+Slicer VFA calibration print